欧美成人免费做真爱大片/好看的国产精彩视频/欧美色偷拍/亚州一级毛片 - 色久悠悠在线观看

 

1、連接輸入電源后，顯示屏，不亮或者沒顯示，一般都是保險管燒了或者電源線問題

①電源線未插緊無法正常供電：檢查電源線插入狀態，插緊后可正常工作：
②電源線故障：更換電源線（如電飯鍋、電腦線等）可正常工作;

③保險管燒壞：需要更換保險管, 檢查儀器后面的電壓是否拔到220V或230V(國內標準電壓) ，如果電壓拔到110V或者115V，則需要拔回220V或230V才可以更換保險管(儀器出廠電源插頭處配有一個備用保險管，拉開更換后即可正常工作) 。更換方式及位置如下圖:

(用螺絲刀撬開，把外面備用的換到里面位置即可)

2、全部配件都戴好，按開始ON/OFF鍵的時候,出現了長鳴的嘀嘀嘀的報警聲音，然后儀器自動停止了工作，離子頭不冒泡：

出現了長鳴的嘀嘀嘀的報警聲音是因為水中含鹽份過高，濃度超過了儀器設定的數值2.5左右, 需要重新換一盆清水, 離子頭重新沖洗一下, 放適量的鹽。

3、每次用完后離子頭要怎么樣處理：

每次排毒完后離子頭可以用清水直接沖洗干凈，然后通風晾干，晾干后用袋子包裏起來（離子頭不能長期直接暴露在空氣中，容易被氧化，使用壽命縮短) 。

4、關于調節模式(MODE)：
模式表示離子頭電解工作的強弱，MODE 1是離子頭電解比較弱，MODE 5是離子頭電解最強。

5、時間調節說明：
儀器開機默認工作時間是30分鐘，必須先調好時間再按開始鍵 ( ON/OFF) , 每按一下時間按鍵，時間增加5分鐘，注意如果儀器開始工作了，則不能調節時間的。最高可調到60分鐘。

1, connect the input power, the display, not lit or not displayed, are generally fuse burned or the power cord problem
① power cord is not plugged can not be normal power supply: check the power cord into the state, plug can be normal work;
② power cord failure: replace the power cord (such as rice cookers, computer lines, etc.) can work properly;
③ fuse burned: need to replace the fuse, check the voltage behind the instrument is pulled to 22oV or 23oV (domestic standard voltage), if the voltage pulled 11ov or 115v, you need to pull back 22oV or 23oV before you can replace the fuse The factory power plug is equipped with a spare fuse, opened to replace the normal work). Replacement and location as shown below:

(With a screwdriver pry open, the outside can be replaced to the inside position)

2, all the accessories are worn, press the start oN / oFF key, there was a long clear sunny sunny alarm sound, and then the instrument automatically stopped working, ion head does not bubble:

Appear the sound of the Ming Ming murmur alarm sound is because the salt water is too high, the concentration exceeds the value set by the instrument 2,5 or so, you need to change a pot of water, re-wash the ion head, put the right amount of salt .

3, after each run high how to handle:

After each detoxification ion head can be rinsed directly with water, then ventilated to dry, dry bag with bag up (ion head can not be long-term direct exposure to the air, easily oxidized, shortened service life).

4, on the adjustment mode (MODE):
Mode indicates the strength of high sub-head electrolysis, MODE 1 is relatively weak ion head electrolysis, MODE5 is the strongest ion head electrolysis.

5, time adjustment Description:
The default working time of the instrument is 30 minutes. The time must be adjusted before pressing the start button (0N / OFF). Each time you press the time button, the time will increase by 5 minutes. Note that the time can not be adjusted if the instrument starts working. Adjustable up to 60 minutes.